AEM has redesigned its original 1-gallon water/methanol injection tank to increase its capacity to 1.15 gallons and has added an anti-starvation reservoir below the low fluid indicator sensor where the WMI mixture collects prior to entering the system. This reservoir helps to prevent fluid starvation under extreme G-loads when the system is running low on fluid. The mounting locations have been repositioned to the four corners of the tank and were designed within the footprint of the overall tank dimensions for easier mounting. These improvements were implemented as a running change to AEM’s gasoline-engine WMI systems and there is no increase in the cost of the tank. The new part number for the redesigned tank is 30-3325.
The new 1.15-gallon AEM WMI tank is included in AEM’s 30-3300 Boost Dependent and 30-3350 Multi Input Water Methanol Injection Kits. It can also be purchased separately and carries a street price of $84.12. The tank includes a conductive low fluid level sensor.
Low Level Fluid Indicator
A more accurate, conductive low level fluid sensor is integrated into the tank and features a positive lock connector with color-matched wires to the wiring harness. The sensor eliminates any chance of incorrect readings due to interference from debris.
1.15 Gallon AEM WMI Tank Features:
THIS PRODUCT MAY BE USED SOLELY ON VEHICLES USED IN SANCTIONED COMPETITION WHICH MAY NEVER BE USED UPON A PUBLIC ROAD OR HIGHWAY, UNLESS PERMITTED BY SPECIFIC REGULATORY EXEMPTION (VISIT THE “EMISSIONS” PAGE AT FOR STATE BY STATE DETAILS. INSTALLERS/USERS LOCATED OUTSIDE THE UNITED STATES SHOULD ACT IN ACCORDANCE WITH THEIR LOCAL LAWS AND REGULATIONS. IT IS THE RESPONSIBILITY OF THE INSTALLER AND/OR USER OF THIS PRODUCT TO ENSURE THAT IT IS USED IN COMPLIANCE WITH ALL APPLICABLE LAWS AND REGULATIONS, AND THIS PRODUCT MUST NOT BE PURCHASED IF THE INTENT IS TO USE IT IN AN UNLAWFUL MANNER.
For more information on this product, check out AEM.