Dean Chen’s 02 Time Attack RSX

Dean Chen’s 02 Time Attack RSX

“When I needed an Exhaust; KTeller was a perfect solution!”
time attack rsx

Using the KTeller 2.5” Exhaust Piping kit in my Time Attack RSX is the perfect solution for my needs, as all “off the shelf”

exhausts impeded exhaust flow so much that I was sacrificing a lot of the top end power that I needed. Installation was easy

that it took me no more then about 30 minutes to line up and weld all the piping, with the muffler to the exhaust tract. KTeller really helped me achieve that edge I needed to be competitive in a tidy, no sacrifice solution. I will definitely be going with KTeller again for the 3” pipe kit once the new engine is done and ready to go.

Interior:

Sparco Evo 2 seat
Sparco harnesses
Momo Race steering wheel
Splash short hub
Megan quick release
Roll Cage by A-Tech Motorsports
Stripped interior
Top Fuel oil pressure gauge
Top Fuel oil temp. gauge
Top Fuel water temp gauge

Exterior:
Type R lip
Type R side skirts
Type R HID headlights
APR GTC-200 RSX-Spec Wing
VIS carbon fiber hood
Integra iS badging
Type R side markers

time attack rsx

Engine:
Darton K24A4 block
2007 Civic Si head
Port and Polish head
5 angle valve job
BDL 70mm throttle body
Buddy Club Spec 3 cams
Buddy Club P1 valve springs
Buddy Club P1 titanium retainers
Rev valves
ARP bolts
Modified S2000 oil pump and sump
Crower rods
JE Pistons (13.5:1 compression)
AEM CAI
PRB intake manifold
Custom race header

K-Teller 2.5” pipe kit

Magnaflow 12616 Muffler
Avid Racing engine mounts
ACT Pro-lite flywheel
Exedy Stage 1 clutch
Hondata K-Pro
Hondata intake manifold gasket
Buddy Club short shifter
Full dyno tune
RSX Type S transmission
Quaife LDS
Samco Radiator hose
JVT Racing 3 row radiator

Suspension:
A’pex N1 coilovers
Neuspeed front strut brace
Neuspeed X-brace
J’s Racing Tie Rods
J’s Racing Roll Center Adjuster
Type R lower control arms
Swift Springs front sway bar
Alex Racing c-pillar brace
D3 Designs rear chassis brace
Type R strut brace
Type R sway bar
Spoon Sports rear lower tie bar
Honsport weld-in rear subframe reinforcement
Energy Suspension bushings
16″ Racing Hart CP-035
225/50-16 Toyo RA1

In Car Electronics:
AMB Transponder